Axminster T-2000CK Istruzioni per gli Interventi Scaricare il pdf (Pagina 16)

Assembly

23. Locate the manometer (17), manometer hose (18)

and the two small clips (24). From the opposite side of

the extractor insert the hose (18) through the hole to

the centre of the NVR’s mounting bracket, see ﬁ g 53.

24. Place one of the small clips (24) over the hose (18),

introduce the hose over the small outlet manifold

on the extraction drum (7) and secure in place, see ﬁ g 54.

DON’T OVERTIGHTEN otherwise the hose could split.

Fig 53-54

25. Place the remaining small clip over the opposite end

of the hose, introduce the hose over the inlet to the rear

of the manometer (17) and secure in place. One again

DON’T OVERTIGHTEN as the hose could split, see ﬁ g 55.

Fig 55

26. To the underside of the motor assembly housing

remove the two Hex bolts and place to one side in

readiness for the next step, see ﬁ g 56.

Fig 56

27. Line up the two holes on the manometer’s mounting

bracket (17) with the two threaded holes to the

underside of the motor assembly. Secure in place

using the two hex bolts you just removed, see ﬁ g 57.

Fig 57

28. Locate the inlet manifold (13) and the remaining

three No: 10 ANC cap head screws (d). Insert the manifold

over the extractor’s inlet and line up the threaded holes

in the inlet with cutout slots in the manifold. Secure the

manifold in place with the cap head screws (d), see ﬁ g

58-59.

Fig 58-59

NVR switch bracket

Hex bolts

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Nessun commento

Axminster T-2000CK Istruzioni per gli Interventi Pagina 16